WPA ConnectionUpdated 25 days ago
Steps to Connect a Water Pipe Adapter (WPA) to a Dry Herb Vaporizer. Please note that it may vary by vaporizer, the DynaVap vap, can connect directly to a water pipe that uses a 10mmm female connection Shop our Water Pipe Adapters here!
Ensure Compatibility:
- First, check that your water pipe adapter (WPA) is compatible with both your vaporizer and your water pipe. The adapter should fit the mouthpiece of your vaporizer and the joint size of your water pipe.
Prepare the Vaporizer:
- Load your dry herb into the vaporizer’s chamber, as you normally would.
- Heat up your vaporizer to the desired temperature. Ensure it’s fully charged or plugged in if necessary.
Attach the WPA to the Vaporizer:
- Ensure that you have the correct WPA attached to your device if applicable.
- Attach the WPA in its place, ensuring a snug fit. The WPA should slide onto or screw into the same spot where the mouthpiece was.
Connect to the Water Pipe:
- Insert the other end of the WPA into the joint of your water pipe. Depending on the design, it should fit directly into the female joint of the water pipe.
- Ensure a tight seal where the WPA connects to the water pipe to prevent any vapor from escaping.
Use the Vaporizer:
- Once everything is connected, you can start inhaling through the water pipe as you would with a regular hit.
- Although the draw may not be as open as drawing from a normal glass bowl, you can steadily increase your draw speed as you inhale to find the sweet spot that builds vapor and allows airflow to prevent clogs.
- The vapor will be cooled and filtered by the water in the pipe, providing a smoother experience.
Adjust as Needed:
- You might need to experiment with the vaporizer's temperature settings and water levels in the pipe to find the optimal setup for your preferences.
Clean After Use:
- After your session, remember to clean the WPA, vaporizer, and water pipe to prevent residue build-up. This will ensure the best performance and taste for future uses.